MonkeyBot assembly instructions

Yes , depending on your age and strength, you may need help from an adult.

This could be because of several reasons:

- Because your batteries are not new and/or a little weak.

I therefore invite you to insert new batteries .

- Because the orange sockets are too tight and your MonkeyBot is not mobile enough.

I therefore invite you to slightly loosen the sockets .

- Because the red and black wires are installed backwards.

I invite you to check the connection of the red and black wires using the explanations in the instructions and the assembly video.

- Because the worm gear and the gear are not in contact with each other.

I therefore invite you to push the worm gear more or less so that it is well engaged with the axle gear.

- Because the MonkeyBot head axle is not inserted into the correct hole of the yellow pulley.

I therefore invite you to check that the axle of the MonkeyBot head is properly inserted into the middle hole of the yellow pulley .

- Because the nipples of the yellow pulleys are not opposite each other.

I therefore invite you to check that the nipple of one pulley is upwards and that the nipple of the other pulley is downwards . Visually, you should see one arm on top of the other.

This could be for several reasons:

- Because your thread is not tight enough.

I therefore invite you to tighten your thread as much as possible.

- Because your thread is not straight enough.

I therefore invite you to ensure that your wire is as horizontal as possible .