Thumbs-up Bot assembly instructions

Yes , depending on your age and strength, you may need help from an adult.

This could be because of several reasons:

- Because your batteries are not new and/or a little weak.

I therefore invite you to insert new batteries .

- Because the orange sockets are too tight and your Thumbs-up Bot is not mobile enough.

I therefore invite you to slightly loosen the sockets .

- Because the red and black wires are installed backwards.

I invite you to check the connection of the red and black wires using the explanations in the instructions and the assembly video.

- Because the worm gear and the gear are not in contact with each other.

I therefore invite you to push the worm gear more or less so that it is well engaged with the axle gear.

- Because the elastic is too tight between the plate and the wheel on the axle or is not positioned on the pulley.

I invite you to check that the elastic is well placed on the pulley and free to move on the rod .

- It is also possible that the arms and rocker arms are not correctly aligned.

I invite you to check that everything is symmetrical .

This may be because the worm gear is too far down on the motor shaft.

I therefore invite you to remove the worm gear and push it in very lightly again (it must be inserted 1/3 of the motor rod ).

This may be due to the installation of the connection wires from the battery box to the motor that are backwards.

I invite you to check the connection of the red and black wires using the explanations in the instructions and the assembly video.